User`s manual

FastTrak100 TX/LP™ Series User Manual

Abort: Stops any Synchronization or Rebuild process if an error is

encountered.

Fix: In most cases, FastTrak100 automatically can correct errors. The

method of correction varies depending on the type of error.

Ignore: FastTrak100 will log the event error and continue the rebuild or

synchronization process. Use this setting if you want to detect the

presence of errors, but do not want to fix these errors at the time. The

user may then decide what to do about the error(s) detected.

WARNING: This may result in mismatched drives under RAID 1 or 0+1.

Interactive: By checking this option, a selection window will appear each

time an error is detected asking the user whether they want to Abort, Fix,

or Ignore the error (see Troubleshooting section).

Dismiss Error Dialogs: Designates the length of time (in seconds) that a

Message box or Error Dialog box appears on screen.

Scheduling Array Synchronization

This section of the Options Window allows a user to schedule when and how often

FastTrak100 will perform synchronization maintenance of a mirrored array.

Disable: Is checked (the default) to turn off automated scheduling of

synchronization. When unchecked, the Scheduling section will be

highlighted (see above).

On Errors section offers four radio button choices for the user to select what

procedure they would like to perform if an Error is detected during a

scheduled Synchronization. There are three types of errors that

FastTrak100 detects -- a data mismatch between the primary and

secondary drive, a physical media error on source or target drive, or a total

disk failure. The options for handling Errors are as follows: