User`s manual

FastTrak100 TX/LP™ Series User Manual

Rebuilding An Array

This command effectively copies or overwrites data from an existing data drive in the

array on to a blank drive. The operation will be typically used when a failed drive has

been replaced with a new drive as part of a mirrored array.

1. To perform a Rebuild, choose the Array Tab View.

2. Right click the array number and choose Rebuild from the context menu.

3. Once Rebuild is selected, you will be asked to “Initialize Rebuild process on

Array #” by clicking OK.

Using Rebuild Wizard

1. Initiating rebuild array will open the Rebuild Wizard Step 1 screen shown below.

2. Select the Target drive that will receive data. Make sure you select the blank

new or replacement drive. The unselected drive will contain “good” data. It will

be the remaining w orking drive of an array, or a system drive containing existing

data that you wish to mirror.

WARNING: Make absolutely sure and double-check which drive is

which. If data exists on the target drive, it will be over-written.