User`s manual

FastTrak100 TX/LP™ Series User Manual

7. Choose “Yes” when asked whether you want to start your computer. Be

sure to remove the diskette from drive A:.

Confirming Driver Installation in Windows 98/95

To confirm that the driver has been properly loaded in Win 95/98, perform the

following steps:

1. Choose “Settings” from the “Start” menu.

2. Choose “Control Panel,” and then double -click on the “System” icon.

3. Choose the “Device Man ager” tab, and then click the “+” in front of “SCSI &

RAID controllers.” “Win9x -ME Promise FastTrak100 TX/LP(tm) Series

Controller” should appear (2 listings will appear if you have the FastTrak100

TX4).

DOS/Windows 3.1x

For first-time installation, follow the standard procedure of installing DOS on to your

hard disk (partition all hard drives with FDISK and format before performing the

following procedure):

1. Insert “Disk 1” of your DOS installation diskettes into drive A:.

2. Type “A:SETUP” at the “A: \” promp t.

3. Continue with normal DOS installation procedure, and refer to your DOS

manual for additional details.

NOTE: The FastTrak100 BIOS supports both DOS and Windows 3.1x without

software drivers.