User`s manual

FastTrak100 TX/LP™ Series User Manual
44
Installing Drivers with Existing Windows 95/98
The following three sections detail the installation of FastTrak100 drivers on a system
that has Windows 95/98 already installed. If you’re installing the FastTrak100 drivers
on a system during a Windows 95/98 installation, see “Installing Drivers During
Windows 95/98 Installation” on page 36.
NOTE: If you have the FastTrak100 TX4, you will need to go through these steps
twice, since the TX4 appears as 2 controllers to the systems.
Windows 98
1. After installing the FastTrak100 controller card and configuring the hard
drives, power up the system and boot Windows.
2. The “Add New Hardware Wizard” will appear, informing you that it has
found a “PCI RAID Controller.”
3. Check the “Search for the best driver for your device” box and click the
Next button.
4. Check the “Specify a Location” box and click Next button.
5. Type “A:\WIN9x-ME” in the text box that appears.
6. Insert the “FastTrak100 Driver” diskette in drive A:.
7. Click on “Next.” The Add New Hardware wizard will say it has found
“Win9x -ME Promise FastTrak100 TX/LP(tm) Series Controller”.
8. Click on “Next,” and then on “Finish.”
9. Choose “Yes” when asked if you want to restart your computer. Be sure to
eject the diskette from drive A:.
Windows 95
1. After installing the FastTrak100 controller card and configuring the hard
drives, power up the system and boot Windows.
2. The “Update Device Drive Wizard” will appear, informing you that it has
found a “PCI Mass Storage Controller.”
3. Insert the “FastTrak100 Driver” diskette in drive A:.
4. Type “A:\WIN9x-ME” in the text box, then click on “Next.” Windows will
inform you that it has found the “Win95 -98 Promise FastTrak100 controller”.
5. Click on “Finish,” and when prompted to insert the “FastTrak100 Driver”
diskette, click on “OK.”
6. If a message informing you that the file “FastTrak.MPD” cannot be found, go
to the “Copy files from:” text box and type: “A: \WIN9x-ME”.