User`s manual

FastTrak100 TX/LP™ Series User Manual
38
Windows NT4
Installing Drivers During Windows NT 4.0 Installation
1. Start the system installation by booting from the Windows NT disk:
a. Floppy install: boot the system with the Windows NT installation
diskettes.
b. Floppyless install: boot from floppy and type “WINNT /B”. After
files have been copied, the system will reboot. On the reboot,
press the “F6” key when the message “Setup is inspecting your
computer’s hardware configuration…” appears.
c. CD-ROM disk install: boot from the CD-ROM disk and press the
“F6” key when the message “Setup is inspecting your computer’s
hardware configuration…” appears.
2. When the “Windows NT Setup” window is generated, press “S” to Specify
an Additional Device(s).
3. Press “O” to select “Other” and press the “Enter” key.
4. Insert the Promise Technology FastTrak100 driver diskette into drive A:
and press the “Enter” key.
5. Choose “WinNT Promise FastTrak100 TX/LP(tm) Series Controller” from the
list that appears on screen, and then press the “Enter” key.
6. The Windows NT Setup screen will appear again saying “Setup will load
support for the following mass storage devices:” The list will include
“WinNT Promise FastTrak100 TX/LP(tm) Series Controller”.
NOTE: If you need to specify any additional devices to be installed, do so
at this time. Once all devices are specified, continue to the next step -
7. From the Windows NT Setup screen, press the Enter key. Setup will now
load all device files and then continue the Windows NT installation.
8. After a successful installation, the “SCSI Adapter Setup” box will show that
the “WinNT Promise FastTrak100 TX/LP(tm) Series Controller” driver has
been installed.