User`s manual

FastTrak100 TX/LP™ Series User Manual
36
Installing Drivers
This section details the FastTrak100 driver installation when used with various
operating systems. The software includes the driver necessary to identify
FastTrak100 to the operating system.
Windows 2000
Installing Driver During New Windows 2000 Installation
1. Start the installation:
a. Floppy Install: Boot the computer with the Windows 2000
installation diskettes.
b. Floppyless Install: Boot from floppy and type “WINNT”. After files
have been copied, the system will reboot. On the reboot, press
<F6> after the message “Setup is inspecting your computer’s
hardware configuration...” appears.
c. CD-ROM Install: Boot from the CD-ROM. Press <F6> after the
message “Press F6 if you need to install third party SCSI or RAID
driver” appears.
2. When the “Windows 2000 Setup” window is generated, press “S” to
Specify an Additional Device(s)
3. Insert the Promise Technology

driver diskette into drive A: and press
“Enter” key.
4. Choose “Win2000 Promise FastTrak100 TX/LP(tm) Series Controller” from
the list that appears on screen, and then press the “Enter” key.
5. The Windows 2000 Setup screen will appear again saying “Setup will load
support for the following mass storage devices:” The list will include
“Win2000 Promise FastTrak100 controller”.
NOTE: If you need to specify any additional devices to be installed, do so
at this time. Once all devices are specified, continue to the next step –
6. From the Windows 2000 Setup screen, press the Enter key. Setup will now
load all device files and then continue the Windows 2000 installation.