User`s manual

FastTrak100 TX/LP™ Series User Manual

Deleting An Array

The Delete Array <4> Menu option allows for deletion of disk array assignments. This

is not the same as deleting data from the drives themselves. If you delete an array by

accident (and before it has been used again), the array can normally be recovered by

defining the array identically as the deleted array.

WARNING: Deleting an existing disk array could result in its data

loss. Make sure to record all array information including the array type,

the disk members, and stripe block size in case you wish to undo a

deletion.

[ Delete Array Menu ]

Array No RAID Mode Total Drv Capacity(MB) Status

Array 1 Stripe 2 16126 Functional

Array 2 Mirror 2 8063 Functional

Array 3 —— —— —— ——

Array 4 —— —— —— ——

[ Keys Available ]

[↑] Up [↓] Down [ESC] Exit [Del] Delete

1. To delete an array, highlight the Array you wish to delete and press the [Del] key.

2. The View Array Definition menu will appear (see below) showing which drives

are assigned to this array.

[ Define Array Menu ]

Array No RAID Mode Total Drv Capacity(MB) Status

Array 1 Stripe 2 16126 Functional

Stripe Block: 64 KB Gigabyte Boundary: OFF

[ Drive Assignments ]

Channel:ID Drive Model Capacity (MB) Assignment

1 : Master QUANTUMCR8.4A 8063 Y

2 : Master QUANTUMCR8.4A 8063 Y

3. Confirm yes to the following warning message with the <Ctrl-Y> key to continue

array deletion: