User`s manual

50
Your choices are as follows:
Abort: Halts the rebuild process. You may select to retry
at a later date.
Break ECC on Target Drive: If the error is detected on the source drive,
FastTrak will copy the bad data sector on to the
target drive to assure that both drives are identical.
If the error is detected on the target drive,
FastCheck will again copy the data contained in
the good sector of the source drive to the target
drive.
Skip the Error Block: The system will log the event error and continue
the rebuild process. Use this setting if you want to
detect the presence of errors, but do not want to fix
these errors yet. You may then decide what to do
about the error(s) detected.
ECC Error Reported on Synchronize
The following screen will appear if a data error is detected on either source or target drive
during Synchronization, that is, if you have set the On Errors setting to “Interactive” in
FastCheck’s Options window for Scheduled Synchronization or for Manual Synchronization
under Notification options.