User`s manual

34
Rebuilding An Array
This command effectively copies or overwrites data from an existing data drive in the array
on to a blank drive. The operation will be typically used when a failed drive has been
replaced with a new drive in the mirrored array.
1. To perform a Rebuild, click the “Array” tab.
2. Right-click the array number and choose “Rebuild” from the context menu.
3. You will be asked to “Initialize Rebuild process on Array #”. Click “OK”.
Using the Rebuild Wizard
1. Initiating the rebuild array will open the Rebuild Wizard Step 1 screen as shown below.
2. Select the Target drive that will receive data. Make sure you select the new blank or
replacement drive. The unselected drive contains “good” data. It will be the remaining
working drive in an array, or a system drive containing existing data that you would wish
to mirror.
WARNING: You must be absolutely sure of the drive. If data exists on the target
drive, it will be overwritten.
3. Click “Next” to proceed to Rebuild Wizard Step 2 (see next page) or “Cancel” to stop.