User`s manual

Using the FastCheck Array Window

Once you start FastCheck, the FastCheck Monitoring Utility window will appear. The main

pane has three window tabs: Array, Controller, and Options. The user can switch between

windows by clicking on the tab. The Array window is the active window by default (below).

The Array window (see above) displays information about the arrays configured through the

FastBuild utility. From this window, you can also perform data Synchronization of mirrored

arrays, or Rebuild data from one drive to a new replaced drive within a mirrored array.

While the Array window does not allow you to change the array configurations directly, it

clearly identifies the drives that are associated in each array as shown in the left pane.

Viewing Array Information

By left-clicking on the Array #, the right pane shows the following information of that array:

RAID mode: Striping, Mirroring or Spanning

Mapping: (similar to physical drive specifications) Shows the # of cylinders, heads,

and sectors of the array’s “virtual” drive as seen by the system.

Size: Storage capacity of the array.