User`s manual

26
Installing the Driver on an Existing Windows NT 4.0
WARNING If you wish to use the existing Windows NT 4.0 hard drive that
will be configured in the Mirrored array as a boot drive, do NOT connect the
hard drive to the RAID IDE connector yet. You must complete the installation
first with the hard drive connected to a standard IDE connector. After you’re
done with the installation, connect the drive to the RAID IDE connector.
1. Select “Settings” from the “Start” menu.
2.
Select “Control Panel” from the “Settings” menu.
3. Double-click the “SCSI Adapters” icon. The “SCSI Adapters” dialog box will appear.
4. Click “Drivers” then click “Add”.
5. In the “Install Drivers” dialog box, select “Have Disk..”.
6. When “Install From Disk” appears, insert the “Promise 20276 RAID Driver” floppy disk
(included in the system board package) into a floppy drive.
7. Type “A:\NT4” in the text box window, then click “OK.”
8. In the “Install Driver” dialog box, select “Win NT Promise MBFastTrak133 Lite
Controller”, and then click “OK.”
9. In the “Select SCSI Adapter Option” dialog box, click “Install.”
10. When you have successfully installed the driver, the “SCSI Adapter Setup” dialog box
will appear showing “Win NT Promise MBFastTrak133 Lite Controller”.
8. Restart your computer. Make sure to remove the diskette from the floppy drive.
Removing the Driver from Windows NT 4.x
1. Select “Settings” from the “Start” menu.
2.
Select “Control Panel” from the “Settings” menu.
3. In “Control Panel”, select “SCSI Adapter,” and then select “Drivers”.
4. Click “Remove”.
5. When you have successfully removed the driver, the “SCSI Adapter Setup” dialog box
will appear showing “Win NT MBFastTrak133 Lite RAID Controller”.