User`s manual

25
Windows NT 4.0
Installing the Driver During Windows NT 4.0 Installation
1. Start the system installation by booting from the Windows NT disk.
a. Floppy: Boot the system using the Windows NT installation diskettes.
b. Floppyless: Boot from floppy and type “WINNT /B”. After the files have been copied,
the system will reboot. Press the <F6> key when the message “Setup is inspecting
your computer’s hardware configuration…” appears.
c. CD-ROM: Boot from the CD-ROM disk and press <F6> when the message “Setup
is inspecting your computer’s hardware configuration…” appears.
2. When the “Windows NT Setup” window appears, press <S> to Specify an Additional
Device(s).
3. Insert the “Promise 20276 RAID Driver” floppy disk (included in the system board
package) into a floppy drive.
4. Press <O> to select “Other” and press the <Enter> key. The driver is in the FastTrak
Driver\NT4 directory of the floppy disk.
5. Select “Win NT Promise MBFastTrak133 Lite (tm) Controller” from the list that appears
on the screen then press <Enter>.
6. The Windows NT Setup screen will appear showing “Setup will load support for the
following mass storage devices:” The list includes “Win NT Promise FastTrak133-Lite
(tm) controller”.
NOTE: If you need to install additional devices, do so at this time. Once all devices are
installed, proceed to step 7.
7. In the Windows NT Setup screen, press the <Enter> key. Setup will now load all device
files and then continue the Windows NT installation.
8. After installing the driver successfully, the “SCSI Adapter Setup” box will show that the
“Win NT Promise FastTrak133-Lite (tm) Controller” driver has been installed.