User`s manual
23
Installing the Driver on an Existing Windows 95/98/ME
The following sections detail the installation of the Windows 98/ME driver on an existing
Windows 95/98/ME system. If you are installing the driver during a Windows 95/98/ME
installation, refer to the “Installing the Driver During Windows 95/98/ME Installation” section.
Windows 98/ME
1. After installing and configuring the hard drives, power up the system.
2. The “Add New Hardware Wizard” will appear informing you that it has found a “PCI
RAID Controller.” Click “Next”.
3. Click the “Search for the best driver for your device” box then click the “Next” button.
4. Click the “Specify a Location” box and then click the “Next” button.
5. Insert the “Promise 20276 RAID Driver” floppy disk (included in the system board
package) into a floppy drive.
6. Type “A:\WIN95-98” in the text box that appears.
7. Click “Next.” The Add New Hardware wizard will appear showing the message “Win95-
98 Promise MBFastTrak133 Lite controller”.
8. Click “Next” then click “Finish.”
9. Click “Yes” to restart your computer. Make sure to remove the diskette from the floppy
drive.
Windows 95
1. After installing and configuring the hard drives, power up the system.
2. The “Update Device Drive Wizard” will appear with the message “PCI Mass Storage
Controller.”
3. Insert the “Promise 20276 RAID Driver” floppy disk (included in the system board
package) into a floppy drive.
4. Type “A:\WIN95-98” in the text box, then click “Next”. The message “Win95-98 Promise
MBFastTrak133 Lite controller” will appear.
5. Click “Finish,” and when prompted to insert the diskette, click “OK”.
6. If Windows cannot find the “MBFastTrak133 Lite.MPD” file, go to the “Copy files from:”
text box and type: “A:\WIN95-98”.
7. Click “Yes” to restart your computer. Make sure to remove the diskette from the floppy
drive.
Confirming Driver Installation in Windows 98/95
To confirm that the driver has been properly loaded in Win 95/98, perform the following
steps:
1. Click “Settings” from the “Start” menu.
2. Click “Control Panel” and then double-click the “System” icon.
3. Click the “Device Manager” tab, and then click “+” that is next to “SCSI & RAID
controllers.” “Win98/ME Promise FastTrak100-Lite controller” will appear.