User`s manual

21
Windows 95/98/ME
Installing the Driver During Windows 95/98/ME Installation
The following sections detail the installation of the Windows 95/98/ME driver while installing
its operating system. If you’re installing the driver on an existing Windows 95/98/ME system,
refer to the “Installing the Driver on an Existing Windows 95/98/ME System” section.
Windows 98/ME
1. After installing and configuring the hard drive(s), partition and format them, if necessary.
2. Follow the standard procedure of installing Windows 98/ME.
3. After installation, go to the “Start” menu and click “Settings.”
4. From the “Settings” menu, click “Control Panel”.
5. In the “Control Panel” window, double-click the “System” icon.
6. In the “System” window, click the “Device Manager” tab.
7. In the hierarchical display under “Other Devices”, click “PCI RAID Controller” and then
click the “Properties” button.
8. Click the “Driver” tab, click “Update Driver,” and then click “Next”.
9. Click “Search for a better driver than the one your device is using now (recommended),”
then click “Next.”
10. Insert the “Promise 20276 RAID Driver” floppy disk (included in the system board
package) into a floppy drive.
11. Click “Specify Location,” and then type “A:\WIN95-98” in the text box.
12. Click “Next”. The message “Win95-98 Promise MBFastTrak133 Lite (tm) Controller” will
appear.
13. Click “Next” then click “Finish”.
14. Click “Yes” to restart your computer. Make sure to remove the diskette from the floppy
drive.
Windows 95
1. After installing and configuring the hard drive(s), partition and format them, if necessary.
2. Follow the standard procedure of installing Windows 95.
3. After installation, go to the “Start” menu and click “Settings.”
4. From the “Settings” menu, click “Control Panel”.
5. In the “Control Panel” window, double-click the “System” icon.
6. In the “System” window, click the “Device Manager” tab.
7. In the hierarchical display under “Other Devices”, click “PCI Mass Storage Controller”
then click the “Properties” button.
8. Click the “Driver” tab then click “Update Driver”.
9. When asked if you want Windows to search for the driver, click “Yes (recommended).”
10. Insert the “Promise 20276 RAID Driver” floppy disk (included in the system board
package) into a floppy drive.