User`s manual

Deleting An Array

“Delete Array <4>” menu allows you to delete disk array assignments. This is not the same

as deleting data from the drives themselves. If you deleted an array by accident (and before

it has been used again), the array can normally be recovered by defining the array identical

to the deleted array.

WARNING: Deleting an existing disk array could result in its data loss. Make

sure to record all array information including the array type, the disk members,

and stripe block size in case you wish to undo a deletion.

[ Delete Array Menu ]

Array No RAID Mode Total Drv Capacity(MB) Status

Array 1 Stripe 2 16126 Functional

Array 2 —— —— —— ——

Array 3 —— —— —— ——

Array 4 —— —— —— ——

[ Keys Available ]

[↑] Up [↓] Down [ESC] Exit [Del] Delete

1. To delete an array, highlight the array you wish to delete and press the <Del> key.

2. View Array Menu will appear (see below) showing the drives that are assigned to this

array.

[ Define Array Menu ]

Array No RAID Mode Total Drv Capacity(MB) Status

Array 1 —— —— —— ——

Stripe Block: 64 KB

[ Drive Assignments ]

Channel:ID Drive Model Capacity (MB) Assignment

1 : Master QUANTUMCR8.4A 8063 Y

2 : Master QUANTUMCR8.4A 8063 Y

3. Confirm yes to the following warning message with the <Ctrl-Y> key to continue array

deletion:

Are you sure you want to delete this array?

Press Ctrl-Y to Delete, others to Abort

4. After deleting the array, you should create a new array in Auto Setup or Define Array

menu.