User`s manual

Creating a Security Array Using An Existing Hard Drive

NOTE: In Auto Setup, only two drives can be used for a single Mirrored array.

Use this method if you wish to use a drive that already contains data and/or is the bootable

drive in your system. You will need another drive of identical or larger storage capacity.

WARNING: Backup all necessary data before proceeding. Failure to follow

this accepted PC practice could result in data loss.

WARNING: If you wish to use a Windows NT 4.x or Windows 2000 hard

drive that will be configured in the Mirrored array as a boot drive, do NOT

connect the hard drive to the RAID IDE connector yet. You must install the

Windows NT 4.x or Windows 2000 operating system and driver with the hard

drive connected to the standard IDE connector. After you’re done with the

installation, connect the drive to the RAID IDE connector. For all other operating systems,

please proceed.

1. Using the Spacebar, choose “Security” under the Optimize Array for section.

2. Press the <Ctrl-Y> keys to Save. The window below will appear.

Do you want the disk image to be duplicated to another? (Yes/No)

Y - Create and Duplicate

N - Create Only

3. Press <Y> to select the Create and Duplicate option. The window below will appear

asking you to select the Source drive.

Source Disk

Channel:ID Drive Model Capacity (MB)

Target Disk

Channel:ID Drive Model Capacity (MB)

[Please Select A Source Disk]

Channel:ID Drive Model Capacity (MB)

1 :Master QUANTUMCR8.4A 8063

2 :Master QUANTUMCR8.4A 8063

[↑] Up [↓] [ESC] Exit [Ctrl-Y] Save

4. Use the arrow keys to choose the drive that contains the existing data to be copied.

FastBuild will copy all data from the Source drive to the Target drive.

5. Press [Ctrl-Y] keys to Save selection and start duplication. The following progress screen

will appear.

Start to duplicate the image . . .

Do you want to continue? (Yes/No)

Y – Continue N – Abort

6. Select <Y> to continue. If you choose <N>, you will be returned to step 1.