User manual

Step 3: Install the Disk Drives
5
2. Attach one Serial ATA data cable to each disk drive. Then attach the other
ends of the cables to the connectors on the FastTrak card (above).
3. Attach the Y-cable power splitters to each of the disk drives.
Caution
Use of removable disk drive enclosures other than Promise
Technology’s SuperSwap is not supported and may result in
performance loss or other undesired results.
Port 1 /
Channel 1
Port 2 /
Channel 2
Port 3 /
Channel 3
Port 4 /
Channel 4
Management
Connector
Individual LED
Connectors
Aggregate LED
Connectors