User manual

FastTrak TX4000
6
IDE 2
IDE 4
IDE 3
IDE 1
LED Pin 1
Figure 2.
TX4000 card
You must use an 80-wire, 40-pin cable when connecting a hard drive to the
FastTrak TX4000 controller card. The FastTrak TX4000 package contains four
80-wire, 40-pin cables.
Notes
The FastTrak TX4000 Controller card is a PCI Plug-n-Play (PnP)
device. No changes are necessary in the Motherboard CMOS
Setup for resources or drive types in most applications.
If you wish to boot from a FastTrak TX4000 drive array AND
continue to use hard drives attached to your motherboard’s IDE
controller, refer to your motherboard manual for the specific BIOS
settings to use in order to establish their proper boot order.