User manual

Fast Trak TX2200 / TX4200 User Manual
58
Unable to partition or format logical disk
This condition may occur when the Reserve Sector of one of the drives has
become corrupt or bad. Removing (erasing) the reserve sector will remedy
any issue related directly to a bad reserve sector.
To remove the reserve sector, follow these steps:
1. Backup any important data from the logical disk.
2. Note the logical disk information, including which drives are used, the
number of drives, RAID Level, etc.
3. Delete the logical disk.
4. Create a new logical disk using the specifications from the previous
logical disk.
5. During the creation process, select the Create and Quick Initialize
option.
6. Partition and format the logical disk using your PC’s operating system.
See page 71.
Logical disk constantly goes critical or offline during reboot
See Unable to Partition or Format logical disk, above.
Cannot rebuild mirrored (RAID 1) logical disk
See Unable to Partition or Format logical disk, above.
Fatal errors or data corruption are constantly reported when reading or
writing to the logical disk
See Unable to Partition or Format logical disk, above.
Warning
Before removing the reserve sector of the drive(s), backup any
existing data. Removal of the reserve sector of any disk drive
permanently deletes all existing data on the drive.