User manual

Fast Trak TX2200 / TX4200 User Manual
56
Intermittent data problems
Overclocking the PCI bus may cause the system to hang or data corruption.
If you experience either of these problems and you are overclocking the PCI
bus, set the PCI bus back to its normal setting to see if this is causing the
errors.
System CMOS Issues
Set motherboard CMOS Boot sequence to boot to FastTrak Controller
On some Motherboard BIOS, it is necessary to set the Boot sequence to
SCSI, A:, C: since the Promise card is identified as a SCSI card.
Motherboard CMOS displays C: or D: drive failure during startup
See the Drive-Related Errors section.
Using an onboard IDE card with FastTrak Controller
If an onboard IDE controller is installed with hard disks, enable support in the
Motherboard Standard CMOS Setup for the drives. Note that the onboard
IDE hard drives will then be the bootable hard disk unless the system BIOS
has a boot sequence setting with the option to specify booting to a different
device.