User manual

Fast Trak TX2200 / TX4200 User Manual

3. Under the Define Array Menu section, press the arrow keys to highlight the

RAID Mode.

4. Press the Spacebar to select the Stripe RAID Mode.

5. Press the arrow keys again to highlight Stripe Block.

6. Press the Spacebar to select the Stripe Block Size you want: 32, 64 or 128

KB.

7. Under the Drive Assignments section, press the arrow keys to highlight a

disk drive.

8. Press the Spacebar to change the Assignment option to Y to add the drive to

the logical disk.

9. Press Ctrl-Y to save the logical disk information.

The window below will appear.

10. If the drives in your logical disk have been used before, press Y for the

Create and Quick Initialize option. Othewise press N to Create only..

If you chose to initialize, press Y to verify that you want your disks initialized.

11. Press Esc twice to exit FastBuild and continue booting your computer..

Note

Before you can use your new logical disk, you must partition and

format the logical disk using your PC’s operating system.

Do you want to do quick initialize

or create only? (Yes/No)

Y - Create and Quick Initialize

N - Create Only

Choose Quick Initialize will delete

any existing data on your hard disks.

Y - Continue, Others - Cancel