User manual

Chapter 2: Installation

The window below will appear.

3. For the Create and Quick Initialize option:

• Press I if you have a two-drive RAID 1 logical disk (above, left).

• Press Y if you have a four-drive RAID 10 logical disk (above, right).

4. Press Y to verify that you want your disks initialized.

5. Press Esc twice to exit FastBuild and continue booting your computer.

Proceed to Chapter 4 on page 39 and install the FastTrak driver.

Note

Before you can use your new logical disk, you must partition and

format the logical disk using your PC’s operating system. See

page 71.

4-drive RAID 10 logical disk

2-drive RAID 1 logical disk

Do you want the disk image to be

duplicated to another or do quick

initialize or create only? (Y/N/I)

Y - Create and Duplicate

N - Create Only

I - Create and Quick Initialize

Do you want to do quick initialize

or create only? (Yes/No)

Y - Create and Quick Initialize

N - Create Only

Choose Quick Initialize will delete

any existing data on your hard disks.

Y - Continue, Others - Cancel