User manual

Fast Trak TX2200 / TX4200 User Manual
14
Proceed to Chapter 4 on page 39 and install the FastTrak driver.
Security Logical Disk (Array) with an Existing Data Drive
Use this setting to create a Mirrored (RAID 1) logical disk with a new disk drive
and an existing drive with data and/or the bootable drive in your system. Use a
new drive of identical or larger storage capacity as the existing drive
Under the Security setting in Auto Setup, FastTrak assigns two drives for a single
Mirrored logical disk. The Create and Duplicate function does not work with a
four-drive Striped/Mirrored logical disk (RAID 10).
Choose this method if you wish to use a drive that already contains data and/or is
the bootable drive from your system. Obtain a second disk drive of equal or larger
storage capacity.
Follow these steps:
1. Press the Spacebar to choose Security under the Optimize Array section.
2. Press Ctrl-Y to Save your selection. The window below will appear.
Note
Before you can use your new logical disk, you must partition and
format the logical disk using your PC’s operating system. See
page 71.
Warning
If you plan to create a Security logical disk using an existing disk
drive, backup any important data. Failure to do so could result in
data loss.
Important
!f you wish to include your current bootable drive using the
Windows 2000, XP or Server 2003 operating system as part of a
bootable Mirrored (RAID 1) logical disk, do NOT connect the disk
drive to the FastTrak yet.
You MUST install the FastTrak driver to this disk drive while it is
still attached to your existing disk drive controller. See Chapter 4
on page 39.