User manual

Chapter 2: Installation
13
4. If you chose to initialize, press Y to verify that you want your disks initialized.
5. Press Esc twice to exit FastBuild and continue booting your computer.
Proceed to Chapter 4 on page 39 and install the FastTrak driver.
Security Logical Disk (Array) with New Drives
Use this setting to create a Mirrored (RAID 1) logical disk with two new disk
drives. If one of the drives has data on it, follow the Creating a Security logical
disk with an Existing Data Drive procedure on the next page.
Under the Security setting in Auto Setup, FastTrak assigns two drives for a single
Mirrored logical disk or four drives (TX4200) for a Striped/Mirrored logical disk
(RAID 10).
To create a logical disk for data protection using new disk drives, follow these
steps:
1. Press the Spacebar to choose Security under the Optimize Array section.
2. Press Ctrl-Y to Save your selection.
The window below will appear.
3. Press N for the Create Only option.
4. Press Esc twice to exit FastBuild and continue booting your computer.
Note
Before you can use your new logical disk, you must partition and
format the logical disk using your PC’s operating system. See
page 71.
Note
When creating a Security logical disk with new drives, a feature
called Gigabyte Boundary will automatically be set to ON. For a
description of this feature, see page 23.
Do you want the disk image to be
duplicated to another or do quick
initialize or create only? (Y/N/I)
Y - Create and Duplicate
N - Create Only
I - Create and Quick Initialize
4-drive RAID 10 logical disk
2-drive RAID 1 logical disk
Do you want to do quick initialize
or create only? (Yes/No)
Y - Create and Quick Initialize
N - Create Only