User manual

Chapter 3: Initial Setup
23
UltraTrak Users
These instructions pertain to the RAID PC
connected to the UltraTrak subsystem. You
must successfully complete this connection
before any remote monitoring connections will
function.
1. When you log into the Message Agent, you
should see the UltraTrak icon and the
Controller icon
below it in Tree View
(right). If you do, your connection is correct.
If you set up your UltraTrak with an array
before installing PAM on your PC, you will
also see the array and drives.
If you do NOT see the Controller icon below
UltraTrak icon (right), click on the UltraTrak
icon
to select it.
2. In Information View, click the Connect button
(See Figure 3-5). The Status should change to Connected.
3. If the Status remains Disconnected, double check your UltraTrak to PC
COM port connection and restart both machines.
Figure 3-5. Information View for UltraTrak device, disconnected (top)
and connected (bottom).