User manual

FastTrak S150 SX4 / SX4000 / SX4000 Lite User Manual
38
Red Hat Linux 8.0, 9.0
Install Driver During New OS Installation
1. Start the RedHat Linux Installation by booting with the installation diskette
or bootable CD ROM.
2. At the Welcome to Red Hat Linux ... installation screen, a prompt labeled
boot: will appear at the bottom of the screen. Type linux dd and press
Enter.
3. When the Installer asks, Do you have a driver disk? click Yes.
4. At the Insert your driver disk and press OK to continue, insert the driver
diskette into the floppy drive and click OK.
5. When the Devices dialog box appears, select Add Device.
6. When the Installer asks, What kind of device would you like to add?, select
SCSI.
7. Scroll down to the Promise FastTrak S150 SX4 ATA-RAID Controller and
click OK.
8. When the Installer displays Promise FastTrak S150 SX4 ATA-RAID
Controller has been found, click Done.
9. Continue with the installation normally.
Note: Check the readme file, included with the downloaded driver files, for
instructions on installing the RAID Console.
Install Driver in an Existing System
1. Insert FastTrak Driver Diskette into the floppy drive.
2. Log in as root.
3. Run mount -r /dev/fd0 /mnt/floppy.
4. Run cd /mnt/floppy; sh ./install.
5. When the Installer asks, You are installing a driver on an existing OS. Is it
true (y/n)?, type Y and press Enter.
6. Run cd; umount /mnt/floppy.
7. Remove the FastTrak Driver Diskette and type reboot to restart the system.
Note: Check the readme file, included with the downloaded driver files, for
instructions on installing the RAID Console.