User manual

FastTrak S150 SX4 / SX4000 / SX4000 Lite User Manual

View Drive Assignments

Press 1 on the Main Menu screen, to see the View Drive Assignments screen

(below). This screen does not allow modifications to any of the four fields.

[ View Drive Assignments ]

[ Keys Available ]

Channel : ID Drive Model Capacity Assignment Mode

CH 1: SEAGATEST380023AS 80630 Free S

CH 2: SEAGATEST380023AS 80630 Free S

CH 3: SEAGATEST380023AS 80630 Free S

CH 4: SEAGATEST380023AS 80630 Free S

Note: * --Bootable Array

[ ] Up [ ] Down [ESC] Exit Mode (S=Serial)

Figure 6. View Drive Assignments screen.

Channel: ID

This field shows the FastTrak Controller channel ID (1-4) to which a particular

drive is attached.

Drive Model

This field identifies the manufacturer, model, and model number (if applicable) of

each drive installed on the FastTrak Controller card.

Capacity (MB)

This field reflects the capacity in MB (megabytes) of each drive.

Assignment

This field identifies the array to which each drive belongs. Assigned drives are

labeled with their disk array (1, 2, 3, etc…). Unassigned drives are labeled “free,”

and are considered “hot spares” to provide fault tolerance. Unassigned drives

may also be used to create a new array at any time.

Mode

On the FastTrak S150 SX4, this channel uses Serial ATA technology and

displays a letter S. It does not apply to the FastTrak SX4000 / SX4000 Lite.