User manual

FastTrak S150 SX4 / SX4000 / SX4000 Lite User Manual
6
Installing the FastTrak Card
The FastTrak RAID Controller card fits into any available:
• 32-bit PCI slot (must be PCI 2.2 compliant)
• The 32-bit portion of a 64-bit PCI slot
on the PC’s motherboard (see Figure 1 below).
1. Remove the cover of your system.
2. Remove the inside slot cover of an available 32-bit PCI slot
2
on the
motherboard.
3. Install the FastTrak card into the open slot (see Figure 1 below). Secure the
bracket to the system’s frame.
4. Attach your system case’s 2- or 4-pin LED cable to the LED connector on
the FastTrak card (see Figures 2 and 3, below). Make sure that pin 1 on the
connector is aligned with pin 1 of the cable.
5. Fasten the FastTrak card bracket to the system case (see below).
Figure 1. Insert the FastTrak card into an open PCI slot.
2
FastTrak SX4000 Lite does not support 66-MHz PCI. Install it in a 33-MHz PCI slot.