Specifications

System Configuration
c. Connect the system fan cable to its power connector (SYSFAN1) on the mainboard.
Figure 4-30: Installing a system fan on the server
7. Observe the post-installation procedures.
Server Configuration
The following sections describe how to configure the HP ProLiant ML110 server using the
following resources:
•
•
HP ProLiant ML110 Server Startup CD-ROM
This CD-ROM allows you to access and copy the needed utilities and drivers to flexible
diskettes, which can be used to configure the server. Some NOS drivers are copied
directly to the server from the Startup CD.
To run the Startup CD, locate a system with NOS installed and has a CD-ROM drive.
Place the disc in the system’s CD-ROM drive. The CD should auto-start, but if it does
not, start it by opening the Startup.htm file found at the root level of the Startup CD.
NOTE: The HP ProLiant ML110 Server Startup CD is not bootable.
NOS drivers
The NOS drivers are copied from the Startup CD to diskettes. The instructions for
installing specific NOS and their respective drivers are provided in the HP ProLiant
ML110 Server NOS Installation Guide. Use this guide to create and copy the appropriate
drivers onto the required diskettes. In some cases you will use the diskettes to load the
appropriate drivers onto the server, or load the drivers directly from the Startup CD onto
the server.
4-28 HP ProLiant ML110 Server Operations and Maintenance Guide