User manual

FastTrak S150 SX4-M Quick Start Guide
4
3. Install the FastTrak card into the open slot (above). Secure the bracket to the
system’s frame.
4. Attach your system case’s 2- or 4-pin LED cable to the LED connector on the
FastTrak card (see Figures 2 and 3, below). Make sure that pin 1 on the
connector is aligned with pin 1 of the cable.
5. Fasten the FastTrak card bracket to the system case (see below).
Step 3: Install the Disk Drives
The FastTrak S150 SX4-M RAID Controller card supports only Serial ATA hard
drives. For optimal performance, install disk drives of the same model and
Important
If you wish to include your current bootable Serial ATA drive using
the Windows operating system as part of a bootable Mirrored
(RAID 1) array on your FastTrak card, do NOT connect the hard
drive to the FastTrak yet. You MUST install the Windows driver
software first onto this drive while it is still attached to your existing
hard drive controller.