User manual

Step 2: Install the FastTrak Card

The FastTrak RAID Controller card fits into any available:

• 32-bit PCI slot (must be PCI 2.2 compliant)

• The 32-bit portion of a 64-bit PCI slot

on the PC’s motherboard (see Figure 1 below).

1. Remove the cover of your system.

2. Remove the inside slot cover of an available 32-bit PCI slot on the

motherboard.

Important

In place of the 64 MB SDRAM DIMM included with the FastTrak

card, you can install a SDRAM DIMM of up to 256 MB for

additional capacity and performance. See Appendix A in the User

Manual.

Notes

The FastTrak S150 SX4-M Controller card is a PCI Plug-n-Play

(PnP) device. No changes are necessary in the motherboard

CMOS/BIOS Setup for resources or drive types in most

applications.