Datasheet

Chapter 4: Maintenance
41
2. Shut down the VessJBOD and remove the I/O module.
See “Replacing an I/O Module” on page 39.
3. Lay the I/O module on a non-static surface and remove the cover attaching
screws, one on each side, then remove the cover.
Figure 3. I/O module cover and attaching screw
4. Remove the four attaching screws. See Figure 4.
5. Detach the fan’s power connector and lift the old fan out of the I/O module.
Figure 4. I/O module cooling fan
Attaching screw
(one each side)
Cover
Attaching
screws (4)
Power
connectors