Datasheet

VessJBOD 1740, 1840 Product Manual
36
• Enter the hostname or IP address of your TFTP server in the field
provided.
• Enter the port number of your TFTP server in the field provided (69 is
the default).
• Enter the filename of the Firmware Update file in the field provided. The
filename is similar to exp.fw.2.03.0000.00.bin.
• Click the Submit button.
For the Local File option:
• Click the Browse button.
• Navigate to the Firmware Update file. The filename is similar to
exp.fw.2.03.0000.00.bin.
• Click the file, then click the Open button.
• Click the Submit button.
6. When the download is completed, click the Next button.
A popup message appears warning you not to reboot the VessRAID during
the firmware update procedure.
7. In the popup message, click the OK button.
The update progress displays. Then a popup message appears to tell you to
reboot the VessRAID.
8. In the popup message, click the OK button.
9. Restart the VessRAIDs and VessJBODs:
• Shut down the VessRAID subsystems. See “Shutting Down the
Subsystem” in the VessRAID Product Manual.
• On the VessJBOD subsystems, turn OFF the power supply switches.
• Wait 30 seconds, then turn ON the VessJBOD power supply switches.
• Wait 30 additional seconds, then turn ON the VessRAID power supply
switches.
To verify the firmware update, run the enclosure command in the CLI. See
page 23.
Note
After you click the Submit button, if WebPAM PROe displays this
message: error transferring image, you entered an incorrect file
name or an incorrect location. Check the information and try
again.