Product manual

VTrak E-Class Product Manual
50
The following information displays:
administrator@cli> net -a list -v
-------------------------------------------------------------------------------
ActiveCtrlId: 1 Port: 1
MaxSupportedSpeed: 1000Mbps LinkStatus: Up
ProtocolFamily: IPv4(Enabled) DHCP: Disabled
IP: 192.168.10.85
IPMask: 255.255.255.0
MAC: 00:01:55:61:18:65
DNS: 192.168.10.11
Gateway: 192.168.10.1
ProtocolFamily: IPv6(Enabled) DHCP: Disabled
IP: 2001:0db8:85a3:0000:0000:8a2e:0370:7334
IPMask: 2001:0db8:fedc:ba98:7654:3210:0246:8acf
MAC: 00:01:55:61:18:65
DNS: 2001:0db8:85a3:0000:0000:8a2e:0370:7001
Gateway: 2001:0db8:85a3:0000:0000:8a2e:0370:7002
Maintenance Mode Settings
For information on maintenance mode, see page 395.
You have the option to make maintenance mode settings at a later time in
WebPRM PROe. See “Making Maintenance Mode Settings” on page 100.
Making Maintenance Mode Settings – Automatically
Automatic settings require a DHCP server on your network. DHCP is currently
supported on IPv4 only.
You make maintenance mode settings for one controller at a time.
To enable automatic maintenance mode settings:
1. At the command prompt, type net -a mod -m -c 1 -f ipv4 -s "dhcp=enable"
and press Enter.
administrator@cli> net -a mod -m -c 1 -f ipv4 -s "dhcp=enable"
After a moment, the comand prompt reappears, indicating that your setting
was successful.
administrator@cli>
2. To verify the settings changes, at the command prompt, type net -a list -m
and press Enter.
The following information displays:
administrator@cli> net -a list -m