Product manual

Chapter 8: Troubleshooting
349
your network. The VTrak becomes a node on your network like any other PC,
server or other component with an IP address.
VTrak ships from the factory IP addresses of 10.0.0.1, 10.0.0.2, and 10.0.0.3.
You must change these addresses to ones that work on your network. You make
the initial IP address setting using the CLI or CLU. See “Setting up the Serial
Connection” on page 39.
Figure 17.Management port connection on the RAID controller
Note that VTrak’s virtual and maintenance ports can accept IP address
assignments from a DHCP server. Use VTrak’s Command Line Utility (CLU) to
enable this feature.
If you manually assigned an IP address to the VTrak but there is a DHCP server
on your network, there is a chance that the server might assign the VTrak’s IP
address to another node. You might see a warning to this effect on your PC’s
monitor. If this happens, WebPAM PROe may not be able to connect. See your
network administrator to work out a suitable arrangement.
Fibre Channel Connections
When there is a connection failure, use WebPAM PROe to verify that VTrak sees
the initiator(s). See “Viewing Fibre Channel Initiators” on page 88 or page 213.
If VTrak sees some initiators but not the one you want, the problem is most likely
elsewhere in the loop or fabric. If VTrak does not see any initiators:
• Check all of the Fibre Channel connections
• Verify that all nodes are properly connected and powered
• Verify that the fabric router or switch is properly connected powered
For more information, see “Managing Fibre Channel Connections” on page 84 or
page 210.
LEDs
State
Dark Amber Green Flashing Green
Connectivity 10BaseT 1000BaseT 100BaseT
Activity No activity Activity
Mgmt
Connectivity LED Activity LED