User manual

Chapter 3: Configuration
49
Halt / Reboot ConnectStor II
The user/supervisor may need to take ConnectStor II offline temporarily in the case of
removing/replacing hard drives or simply reboot the unit due to certain other network issues.
Clicking on the Halt/Reboot command from the Configuration side menu will display two
buttons: Halt ConnectStor II or Reboot ConnectStor II as seen below:
Halting ConnectStor II
1. Clicking the Halt ConnectStor II button will shut down the unit remotely. A
confirmation window will appear.
2. Click OK to confirm. A second confirmation window will appear.
3. Click OK to confirm. The browser will ask permission to close the window.
4. Close your browser window.
NOTE: To restart the ConnectStor II, turn the power switch off
and then on again.
Remotely Rebooting ConnectStor II
1. Clicking the Reboot button reboots the ConnectStor II operating system.
2. Click OK to confirm. A second confirmation window will appear.
3. Click OK to confirm. The browser will ask permission to close the window.
4. Close your browser window.
5. In your browser, reconnect to the ConnectStor II and login.
CAUTION: Users temporarily will be unable to access the unit's
data until the system reboots completely.