User manual

Chapter 2: Getting Started

5. Type the IP address you want to use in the IP Address: field (above).

6. Type 255.255.255.0 in the Subnet Mask: field.

7. Type the IP address of your Gateway server in the Gateway: field.

8. Click the Assign IP button.

CAUTION: Check and recheck your entries in this menu.

Incorrect entries will prevent you from seeing the ConnectStor

II on your system.

After you click the Assign IP button, IPassign will verify that your settings are

correct and the requested IP address is not already in use. If everything is correct, the

IPassign dialog box will display the new IP address information (below).

NOTE: If there is no IP address assigned within ten minutes,

either through the APassign utility or the DHCP server, the

ConnectStor II will set its own IP address to 192.168.204.204.