Owner's Manual

9
ASSEMBLY INSTRUCTIONS
Motor Screw
Blade Arm
Blade Screw
Blade Washer
Blade Arm
Blade
Canopy
Mounting Bracket Screw
J-shaped
slot
Round
hole
Black (hot)
White (neutral)
Bare/Green
(ground)
Black Blue White
Green
14
15
13
12
WARNING: Do NOT wire the
fan motor to a variable-speed
wall control.
13. Raise the canopy, ensure the two mounting bracket
screws are aligned with the J-shaped slots in the canopy.
Then turn the canopy in a clockwise direction until the
mounting bracket screws are completely engaged in
the J-shaped slots. Install the two previously removed
mounting bracket screws in the round holes. Securely
tighten all mounting bracket screws.
14. Partially insert the blade screws along with the blade
washers through the blade and into the blade arm.
Tighten each blade screw with a Phillips screwdriver (not
included), starting with the one in the middle. Repeat this
step for the remaining blades and blade arms.
15. Install the blade arm to the underside of the motor
assembly with previously removed motor screws. Tighten
each blade arm completely before moving to the next.
12. Use wire connectors to connect the fan wires to the
power supply wires according to the wiring diagram and
the following instructions:
• Connect the white wire from the fan to the white
(neutral) supply wire.
• Connect the black and blue wires from the fan to the
black (hot) supply wire.
• Connect the green wire from the downrod and mounting
bracket to the bare/green (ground) supply wire. Note: The
downrod is not used for closemount installation, so there
will only be two green wires to connect.
Note: If a second hot/power wire is available from the
outlet box, connect it to the blue (light power) fan wire for
separate fan and light switches.
Important: After the connections have been made, the
wires should be turned upward and pushed carefully
up into the outlet box. Place the black and white wire
connections on opposite sides of the outlet box.
Wire Connector