Owner's Manual

7
Tab
Slot
Downrod
8. Install the ball end of the downrod into the opening of
the mounting bracket. Rotate the downrod until the tab in
the mounting bracket is seated in the slot in the downrod
ball.
WARNING: The fan and/or downrod should not rotate in
the mounting bracket, if installed correctly. Failure to align
the slot in the downrod ball with the tab on the mounting
bracket may result in fan falling causing serious injury or
death.
ASSEMBLY INSTRUCTIONS
Mounting
Bracket
Downrod Pin
Downrod
Clip
Yoke
Downrod
Set Screw
Canopy
Yoke Cover
Downrod
Braided
Cable
Yoke
6
7. Insert the downrod into the yoke and reinstall the
downrod pin and downrod clip. Then retighten the two
set screws.
Note: With wiring extending out of the downrod, measure
8 inches of lead wire and cut the excess wire with wire
cutters (not included). Then strip 1/2” of insulation from
the end of each wire.
WARNING: Do not cut braided cable.
6. Feed the wires and braided cable coming from the yoke
through the yoke cover, canopy, and downrod.
7
8
Downrod
Clip
Set Screw
Yoke
Downrod
Pin
Downrod
5
5. DOWNROD MOUNT - Remove the downrod clip and
downrod pin from the downrod. Then loosen but do not
remove the two set screws in the yoke at the top of the
motor assembly.