Owner's Manual

Motor Screw

Motor Block

Closemount Screw

Mounting

Bracket

Hook

Canopy

ASSEMBLY INSTRUCTIONS

Mounting Bracket Screw

2. Loosen all four mounting bracket screws and

completely remove the two screws from the round holes

in the canopy. Then remove mounting bracket from the

canopy and save them for later. Remove the canopy from

the mounting bracket. Install the mounting bracket to

the outlet box (sold separately) using the screws and

washers provided with the outlet box.

WARNING: To reduce the risk of re, electric shock,

or personal injury, mount to the outlet box marked

“acceptable for fan support” and use the mounting

screws and washers provided with the outlet box.

3. Remove the ten motor screws and ve motor

blocks from the underside of the motor. Discard the

motor blocks but save the motor screws for blade arm

installation.

1. Turn OFF the electrical power at the main fuse or circuit

breaker.

DANGER: Failure to disconnect the power supply prior to

installation may result in serious injury or death.

4. CLOSEMOUNT INSTALLATION (Optional) -

a. Remove the three Phillips-head closemount screws from

the top of the motor assembly.

b. Remove the canopy cover from the bottom of the

canopy.

c. Align the holes in the bottom of the canopy with the

screw holes in the top of the motor assembly. The larger

holes in the canopy will encompass the three pre-installed

screws.

d. Secure the canopy to the top of the motor assembly

with the three closemount screws.

e. Hang the fan on the hook of the mounting bracket.

Proceed to Step 9.