Owner's Manual

Bulb
10
ASSEMBLY INSTRUCTIONS
16. Remove the three switch housing screws from the top
edge of the switch housing cap. Then, connect the single-
pin connectors from the switch housing to the single-pin
connectors from the light kit -- blue to black and white to
white. Then, using the three previously removed switch
housing screws, secure the light kit to the switch housing.
17. Install the E26-base bulbs into the sockets on the light
kit.
Important: Make sure to allow the bulbs and light kit to
cool before replacing the bulbs.
16
17
18
Switch
Housing
Screw
Switch Housing
Single-pin
Connector
19
19. NO LIGHT KIT OPTION (OPTIONAL)
Remove the light kit from the switch housing cap by
removing the hex nut and washer from inside the switch
housing cap. Insert plug button into the center of the
switch housing cap.
18. Remove the preassembled nial, nial cap, hex nut
and rubber washer from the light kit. Feed the pull chain
coming from the grommet in the light kit through the o-
center hole in the glass bowl. Feed the pull chain coming
from the center of the light kit through the center hole in
the glass bowl. Lift the glass bowl onto the threaded rod at
the bottom of the light kit.
Secure glass bowl with rubber washer and hex nut. Then
attach nial cap and nial.
Proceed to Step 22.
Light Kit
Light Kit
Light Kit
Glass Bowl
Rubber Washer
Hex Nut
Finial Cap
Finial
Lock Washer
Hex Nut
Switch
Housing
Cap
Plug Button