Owner's Manual

Switch
Housing
Screw
Switch
Housing
Single-pin
Connector
Fan Pull
Chain
Reverse
Switch
Light Pull
Chain
9
ASSEMBLY INSTRUCTIONS
17. Remove the three switch housing screws from the
top edge of the light kit. Then, connect the single-pin
connectors from the switch housing to the single-pin
connectors from the light kit -- blue to blue and white to
white. Then, using the three previously removed switch
housing screws, secure the light kit to the switch housing.
Light Cage
Bracket
Bulb
Cage Screw
Shade
16. Remove the four cage screws from the brackets inside
the shade. Install the E26-base LED bulb in the socket.
Then attach the light cage to the shade using the four
cage screws. Repeat for each shade.
18. Attach pull chain extensions to the pull chains.
Note: When facing the reverse switch, the pull chain on
the left controls the light and the right controls the fan.
16
17
18
19
19. Installation is complete.
Turn ON the electrical power at the main fuse or circuit
breaker.