Owner's Manual

8
ASSEMBLY INSTRUCTIONS
Motor Screw
Blade Arm
Blade Screw
Blade Washer
Blade Arm
Blade
Canopy
Round
Hole
Mounting
Bracket Screw
J-slot
Black (Hot)
Wire Connector
White (Neutral)
Bare/Green (Ground)
Black Blue White Green
14
15
13
12
WARNING: Do NOT
wire the fan motor
to a wall control.
13. Align the canopy over the loosened mounting bracket
screws. Place the J-slot of the canopy onto the mounting
bracket screws and rotate clockwise. Secure the canopy
with the two previously removed mounting bracket
screws. Tighten all the mounting bracket screws securely.
14. Partially insert three blade screws along with blade
washers through the blade and into the blade arm.
Tighten each blade screw starting with the one in the
middle. Repeat this step for the remaining blades.
15. Install the blade arm to the underside of the motor
assembly with previously removed motor screws. Tighten
each blade arm completely before moving to the next.
12. Use wire connectors to connect the fan wires to the
power supply wires according to the wiring diagram and
the following instructions:
• Connect the white wire from the fan to the white
(neutral) supply wire.
• Connect the black and blue wires from the fan to the
black (hot) supply wire.
• Connect the green wire from the downrod and mounting
bracket to the bare/green (ground) supply wire. Note: The
downrod is not used for closemount installation, so there
will only be two green wires to connect.
Note: If a second hot/power wire is available from the
outlet box, connect it to the blue (light power) fan wire for
separate fan and light switches.
Important: After the connections have been made, the
wires should be turned upward and pushed carefully
up into the outlet box. Place the black and white wire
connections on opposite sides of the outlet box.