Owner's Manual

6
Downrod Pin
Downrod Clip Yoke
Downrod
Set Screw
Canopy
Braided
Cable
Yoke Cover
Downrod
Yoke
Downrod
Clip
Set Screw
Yoke
Downrod
Pin
Downrod
Tab
Slot
Downrod
7
8
6
5
ASSEMBLY INSTRUCTIONS
Mounting
Bracket
8. Lift the downrod into the mounting bracket. Rotate
the downrod until the tab in the mounting bracket is
seated in the slot in the downrod ball.
WARNING: The fan and/or downrod should not rotate
in the mounting bracket, if installed correctly. Failure
to align the slot in the downrod ball with the tab on
the mounting bracket may result in fan falling causing
serious injury or death.
7. Insert the downrod into the yoke and reinstall the
downrod pin and downrod clip. Then retighten the two
set screws.
Note: With wiring extending out of the downrod,
measure 8 inches of lead wire and cut the excess wire with
wire cutters (not included). Then strip 1/2” of insulation
from the end of each wire. Do not cut braided cable.
6. Feed the wires and braided cable coming from the yoke
through the yoke cover, canopy and downrod.
5. DOWNROD MOUNT - Remove the downrod clip and
downrod pin from the downrod. Then, loosen but do not
remove the two set screws at the top of the yoke.