Owner's Manual

9
ASSEMBLY INSTRUCTIONS
16. Remove the three switch housing screws from the top
edge of the switch housing cap. Then, connect the single-
pin connectors from the switch housing to the single-pin
connectors from the light kit -- blue to black and white to
white. Then, using the three previously removed switch
housing screws, secure the light kit to the switch housing.
17. Install the E26-base LED bulbs into the sockets of the
light kit.
16
17
18
Switch Housing
Screw
Single-pin
Connector
Fabric Shade
19
Bulb
Finial
Finial Cap
Lens
Grommet
19. Attach pull chain extensions to the pull chains.
Note: When facing the reverse switch, the pull chain on
the left controls the light and the right controls the fan.
Skip to Step 22.
Fan Pull Chain
Light Pull Chain
Reverse
Switch
18. Remove the nial cap and nial from the threaded rod
at the bottom of the light kit. Then, feed the pull chains
from the switch housing down through the grommets in
the bottom of the light kit and through the appropriate
holes in the lens and nial cap. Lift the center hole in the
lens and nial cap over the threaded rod and secure with
nial.
Important: Orient the lens so the pull chain takes a direct
path from the grommet to the o-center hole in the lens.