Owner's Manual

4. CLOSEMOUNT INSTALLATION (Optional) -

a. Remove the three Phillips-head closemount screws from

the top of the motor assembly.

b. Remove the canopy cover from the bottom of the

canopy.

c. Align the holes in the bottom of the canopy with the

screw holes in the top of the motor assembly. The larger

holes in the canopy will encompass the three pre-installed

screws.

d. Secure the canopy to the top of the motor assembly

with the three closemount screws.

Proceed to Step 9.

Closemount

Screw

Hook

Motor Screw

Washer

Motor Block

ASSEMBLY INSTRUCTIONS

Mounting

Bracket Screw

2. Remove the mounting bracket by removing the two

mounting bracket screws from the round holes in the

canopy. Then loosen the other two mounting bracket

screws from the J-slots. Retain the mounting bracket

screws for later. Install the mounting bracket to the

outlet box (not included) using the screws and washers

provided with the outlet box.

Warning: To reduce the risk of re electric shock,

or personal injury, mount to the outlet box marked

“acceptable for fan support” and use the mounting

screws and washers provided with the outlet box.

3. Remove the ten motor screws, washers, and ve motor

blocks from the underside of the motor. Discard the

motor blocks and washers, but save the motor screws for

blade arm installation.

1.Turn OFF the electrical power at the main fuse or circuit

breaker.

DANGER: Failure to disconnect the power supply prior to

installation may result in serious injury or death.

Mounting

Bracket