User guide

3.) Button
•While unit is in Bluetooth or TF card Playback mode, press once to play or pause the
current track.
•In Bluetooth mode, when receiving an incoming call on your cell phone, tap this button
once to answer the phone, press this button again or press and hold this button to end
the call or ignore the incoming call.
4.)Built-in Microphone
5.)Battery charging Indicator (Red color)
•Rapid flashing =low battery
While charging :
•Flashing =charging
•Steady Red= full charged
6.)Aux-In Jack
7.)Mini USB Charging jack
8.)TF card slot
9.)Operating mode indicator (Red/Blue/Purple)
•Blue color =Bluetooth mode
•Purple color= TF card playback mode
•Red=Aux-in mode
10.)Power On/Off selector
Should you experience difficulties in the use of this player, please refer to the following
chart.
NO Sound The Pyram battery is
dead.
Recharge the Pyram
battery.
The Pyram is not
linked with the cell
phone.
Go through “Speaker
Operations” process to link
the speaker.
Volume set too low.
Increase the volume of
your device.
No audio
signal via the
Bluetooth
connection
Speaker is not paired
to the audio source.
Check whether a
connection exists. If
necessary, pair the
speaker again to the audio
source.
Volume too low
Increase the volume on the
speaker
Increase the volume on the
audio source.
Speaker
cannot be
connected
Pairing does not work
Check whether the audio
source supports the A2DP
protocol
Audio source
is switched off
Switch on the audio source
Bluetooth is switched
off at the audio
source.
Switch on the Bluetooth
function in the audio
source.
Bluetooth version is
not supported.
Use a different playback
unit.
Poor sound
quality from a
Bluetooth
®
device
Bluetooth device is
almost out of range of
the Pyram
Move your Bluetooth
device closer to the
Pyram
9