Specifications

Revision: 1.0 www.CommFront.com Page 7 of 16
(Figure 8)
4) When the driver is successfully installed, the following window will pop up,
confirming that the driver installation of “USB Serial Converter” has been completed.
Click on the “Finish” button to continue (Figure 9).
(Figure 9)
5) The 2
nd
“Found New Hardware” window will pop up, prompting you to install the
driver for “USB Serial Port”. DO NOT close this window! And repeat steps 1) to 4)
to install the driver for “USB Serial Port”.
6) When the 2
nd
driver installation is completed, remember to check the Windows
Device Manager to confirm that the drivers are installed successfully (Figure 2). The
USB-485-1 will show up in the Windows Device Manager: under “Ports (COM &
LPT)” – labeled as “USB Serial Port (COMx)”, and under “Universal Serial Bus
controllers” - labeled as “USB Serial Converter”.
Revision: 1.0 www.CommFront.com Page 8 of 16
 Example 3 (Windows 2000)
1) Insert the CD into the drive and connect the USB-485-1 to an available USB port,
the “Found New Hardware Wizard” window will pop up. Click on the “Next” button to
continue (Figure 10).
(Figure 10)
2) Select “Search for a suitable driver for my device (recommended)” and click on the
“Next” button to continue (Figure 11).
(Figure 11)
3) Check the box of “CD-ROM drives”, and then click on the “Next” button to continue
(Figure 12).