Specifications

Revision: 1.0 www.CommFront.com Page 5 of 16

(Figure 4)

4) When the driver is successfully installed, the following window will pop up -

confirming that the driver installation of “USB Serial Converter” has been completed

successfully. Click on the “Close” button to continue (Figure 5).

(Figure 5)

5) The 2

“Found New Hardware” window will pop up, prompting you to install the

driver for “USB Serial Port”. DO NOT close this window! And repeat steps 1) to

4) to install the driver for “USB Serial Port”.

6) When the 2

driver installation is completed, remember to check the Windows

Device Manager to confirm that the drivers are installed successfully (Figure 2). The

USB-485-1 will show up in the Windows Device Manager: under the “Ports (COM &

Revision: 1.0 www.CommFront.com Page 6 of 16

LPT)” – labeled as “USB Serial Port (COMx)”, and “Universal Serial Bus controllers” -

labeled as “USB Serial Converter”.

 Example 2 (Windows XP)

1) Insert the CD into the drive and connect the USB-485-1 to an available USB port,

the “Found New Hardware Wizard” window will pop up. Select “No, not this time”

and click on the “Next” button to continue (Figure 6).

(Figure 6)

2) Select “Install from a list or specific location (Advanced)” to install the driver from

CD (Figure 7).

(Figure 7)

3) Select “Search for the best driver in these locations” and check the box of “Search

removable media (floppy, CD-ROM…)”. Then click on the “Next” button (Figure 8).