User's Manual
Simpleflowinc.com
6
SET-UP AND SYNC AQUA ACTUATOR WITH AQUA REMOTE
Once you have installed the Aqua Actuator and have the Aqua Remote in hand, proceed
with the following steps to sync and control the actuator using the remote:
1. On the remote, enter your remote specific PIN to log in. (Default is 0000)
P
I
N
:
0
0
0
0
2. On the remote, enter the Unique Property ID (UPID) of the property where the valve
actuator will be located and associated with. Special Note: It is recommended to use
the street address of home or business.
U
P
I
D
:
0
0
0
0
0
0
O
P
E
R
A
T
E
D
E
V
I
C
E
S
S
E
T
T
I
N
G
S
C
H
A
N
G
E
P
I
N
A
B
O
U
T
3. On the valve actuator, press and hold the open/close button for 5 seconds to enter
into the pairing mode.
a. The light behind the button on the actuator will begin to blink once in pairing
mode.
4. Next go to the Settings menu on the remote. Click OK and wait for remote to search
for actuators within range.
U
P
I
D
:
0
0
0
0
0
0
O
P
E
R
A
T
E
D
E
V
I
C
E
S
S
E
T
T
I
N
G
S
C
H
A
N
G
E
P
I
N
A
B
O
U
T